First, a visual mold testing in Arlington of the building is performed to detect moisture and mold, looking for their causes and location. Thermal imaging technology is used as a supplemental resource to help confirm or verify areas that cannot be seen with the naked eye.
We investigate all areas thoroughly for plumbing leaks, hidden roof leaks, damaged or damp insulation, and intrusion of water and moisture that could lead to structural damage and microbial growth.
Air sampling can be used to detect a higher than normal concentration of spores in a given medium. This technique can be used when the presence of mold is not evident; for example when fungal organisms are invisible, but some people experience unexplained symptoms, possibly due to exposure to bioaerosols.
An indoor air sample may be accompanied by an outdoor air sample for comparison. In general, when the results indicate a higher fungal concentration indoors or the type of mold there is different from that found outdoors, or both at the same time, further investigation is warranted.
Not all molds are detected by sampling the air. Note that an air sample only indicates that a bioaerosol was present at the time of collection. However, this technique is useful when used before and after corrective action is taken. It is also used during the implementation of these measures to confirm that the air quality meets the standards set for human occupancy if the building is still partially occupied.
Air sampling for mold requires the use of specialized instruments used by occupational hygienists and indoor air quality experts following the protocol established by the manufacturer.
It is difficult to establish a direct link between the presence of mold and health problems.
The possible symptoms of exposure to molds can vary from person to person. Some of the most common complaints include allergies, asthma, irritation of the nose, eyes and / or skin, runny nose, etc.
It is difficult to establish a direct link between the presence of mold and health problems. Other indoor pollution factors such as tobacco smoke, solvents, fine particles, radon, carbon monoxide can also play a role.
History of water problems
When preparing for mold testing in Arlington it is important to think about recent water problems you have had in your home.
If you hire a professional mold testing in Arlington, it’s a good idea to let them know about leaks, floods, or any other moisture problems you’ve had in your home. If you are conducting a mold inspection yourself, knowing where there have been water problems will give you clues as to where mold is most likely to be found.
There may even have been water problems that you never knew about. Look for signs of moisture, such as bulging surfaces, water spots or peeling paint, to find recent water problems that have led to mold growth.
You should also identify areas with the greatest potential for water problems, such as where pipes go, air conditioning vents, roofs with potential leaks, or places where water collects after a flood.